Xantrex XW4024 230 50 Installation Manual page 24

Inverter/Charger Installation
Wall stud
Wallboard
Plywood
(optional)
Mounting
plate
152 cm from floor puts
the inverter information
panel at approx. 165 cm
high.
Figure 2-3 Mounting the Bracket for the Xantrex XW Inverter/Charger or Distribution Panel
2–6
Side View
Locate the wall studs.
1
If necessary, enhance the support surface with a 20 mm plywood panel secured to
2
the wall studs. The plywood should span at least three wall studs.
Use hardware (not provided) sized to support the weight of the equipment to
3
secure the plywood to the wall.
Using a level, secure the first mounting bracket to the wall. Use recommended
4
anchoring hardware to secure the plate (see Table 2-1).
Mount the next bracket adjacent to the first one. The brackets are designed to
5
interlock, so additional mounting brackets are easily installed without additional
measuring or levelling.
This manual for use by qualified personnel only
Wall studs 400 mm on center
behind wallboard
Multiple mounting plates should fit together as
shown.
Add 20 mm plywood if
additional support is
needed.
975-0384-01-02