Table of Contents
Advertisement
Enable the Inverter
975-0384-01-02
Figure 2-17 Power-up Display
CAUTION: Equipment Damage
Prior to activating the inverter, make sure that all AC loads are disconnected from
the output of the inverter.
By default, Invert mode is enabled and the unit should start inverting upon
transitioning from Standby mode. If Invert mode is disabled, the display will show
"
" once out of Standby mode. If the unit powers up in Standby mode, press
the O
/O
button momentarily to change the mode from Standby to Operating.
N
FF
To enable the inverter:
◆
Press the inverter's O
briefly appears on the inverter information panel to indicate that the
inverter is enabled.
To disable the inverter:
◆
Press the inverter's O
briefly appears on the inverter information panel to indicate that the
inverter is disabled.
This manual for use by qualified personnel only
Basic Functional Test - Single Inverter
/O
button and the Equalize button at the same time.
N
FF
/O
button and the Equalize button at the same time.
N
FF
Note: If the inverter was
previously powered up then it
will power-up in the last
operating state (Operating or
Standby)
All LEDs temporarily turn on.
O
/O
Button
N
FF
2–29
Hide quick links:
Advertisement
Table of Contents
