Revision History - Furuno TECDIS Installation Manual

TECDIS Installation Manual

Revision History

Revision 1.0 (13.05.2005)
• Initial revision
Revision 1.1 (17.06.2005)
• Illustrations updated
• Wiring and signaling diagrams added
• Hardware installation for auxiliary components added
• Some updates to setup software description
Revision 1.2 (29.08.2005)
• Equipment list updated
• Compass safe distance instructions added
Revision 1.3 (05.01.2006)
• Updated chapter 3.4, size and sensors. New choices: "backward (gyro-180º)" and "Raise
alarm if HDT1-HDT2 > 2.5º"
• Updated illustrations in chapter 4.1.
Revision 1.4 (04.08.2006)
• Chapter 3.2.1: Updated text. Port collision warning (case 69, 19.04.06)
• Chapter 3.4: Updated text and illustrations. New function: shiphandle mode (case 53,
30.03.06)
• Chapter 4.1: New function: time zone selection (case 98, 22.05.06)
Revision 1.5 (22.10.2006)
• Chapter 3.2: Updated illustration
• Chapter 3.2.6: Added description of RCU-018 ctrl field.
• Chapter 3.4: Updated illustration
• Chapter 3.5: Updated illustration
• Chapter 3.6: Updated illustration
• New Chapter 3.7 (Track Control)
• Compass Safe Distance table on page 1 updated
• Equipment Lists on page 5 updated
• Installation Overview illustration updated
• Specifications updated
• Updated mounting section
• Added mounting Chapter 1.3 Control Unit Furuno RCU-018
• Added Chapter 2.1, HT405P4 Wiring diagram
• Added Chapter 2.3, Processor connectors, HT405P4 TEL-A1
• Renumbered chapters following 2.1
Revision 1.6 (30.04.2007)
• Compass Safe Distances on page 1 updated
• Equipment List on page 5 updated
• Installation Overview illustration updated
• Specifications for HT 405P4 on page 7 updated
Page 76