Track Control; Starting Requirements - Furuno TECDIS Installation Manual

TECDIS Installation Manual

3.7 Track Control

On this tab, settings for connection to Raytheon Anschütz AP2025 PLUS autopilot and Track
Control can be set.
Refer to Raytheon Anschütz AP2025 PLUS Installation Manual for installation and
configuration of the autopilot.
same heading and log sensor inputs!

3.7.1. Starting Requirements

The values in this area specify the conditions needed before Track Control mode can be
activated.
Max course deviation
Max lane deviation
Min. speed
NB: The autopilot and TECDIS must be supplied with the
The maximum number of degrees the course over ground (COG) of
the vessel can differ from the planned course.
The maximum distance of the vessel position from the planned
route leg, expressed as a multiplier of the planned route leg lane
width. (For example, if the lane setting for the initial planned
route leg is 100m, and 'max lane deviation' is set to x2, the vessel
position can be up to 200m from the planned route leg when Track
Control is activated.)
The minimum speed of the vessel in knots.
Page 50