Chapter 1: Mounting; Monitor Unit - Furuno TECDIS Installation Manual

TECDIS Installation Manual

Chapter 1: Mounting

1.1 Monitor Unit

The monitor unit can be flush mounted in a console panel, or mounted on desktop using optional
accessories.
When selecting a mounting location, keep in mind the following points:
1. Select a location where the display unit can be viewed conveniently and where the screen
can be viewed while facing towards the bow.
2. Select a location where vibrations are down to a minimum, try to avoid vibrations by
adding strength to console where monitor is about to be installed.
3. Locate the unit out of direct sunlight and away from heat sources because of heat that can
build up inside the cabinet.
4. Locate the equipment away from places subject to water splash and rain.
5. Leave sufficient space on the sides and rear of the unit to facilitate maintenance.
6. A magnetic compass will be affected if the monitor unit is placed too close to the
magnetic compass. Observe the compass safe distances to prevent deviation of a magnetic
compass.
7. An optional monitor bracket can be supplied for tabletop installations.
Screws for mounting the monitor to the console are supplied. When bracket is used screws for
attaching bracket and monitor together is supplied. Screws for mounting bracket to table are not
supplied.
Page 12