Installation; Environmental Conditions; Installation Of The Router; Installation Of Sim Cards - NetModule NB2700 User Manual

4. Installation

4.1. Environmental Conditions

The following precautions must be taken before installing a NB2700 router:
• Avoid direct solar radiation
• Protect the device from humidity, steam and aggressive fluids
• Guarantee sufficient circulation of air around the device
• The device is for indoor use only
Parameter
Input Voltage
Operating Temperature Range
Humidity
Altitude
Over-Voltage Category
Pollution Degree
Ingress Protection Rating

4.2. Installation of the Router

The NB2700 is designed for mounting it on a worktop or wall. Please consider the safety
instructions and the environmental conditions in chapter 2.

4.3. Installation of SIM Cards

SIM cards can be inserted by sliding it into one of the designated holes on the front
panel. By using a small paper clip (or similar) you will need to press it a bit until it
snaps into place. For removing the SIM, you will need to push it again in the same
manner. The SIM card will then rebounce and can be pulled out.
Rating
12 V to 48 V
DC
main board:
25 C to +60 C, UMTS/WLAN: 25 C
to +70 C
0 to 95% (non-condensing)
up to 4000m
II
2
IP40 (with SIM and USB covers mounted)
Table 4.1.: Operating Conditions
20
( 15% / +20%)
DC
40 C to +80 C, LTE: