Registration Clutch - Canon imageRUNNER 330 Service Manual

CHAPTER 7 PICK-UP/FEEDING SYSTEM

3. Registration Clutch

1) Remove the four screws, and detach the
rear cover; then, remove the three screws,
and detach the flywheel.
2) Remove the registration clutch [1],
remove the clip ring [2], and disconnect
the connector [3].
When mounting the registration clutch,
cheek to make sure that the grip ring has been
mounted correctly.
[3]
[2]
[1]
Figure 7-254
4. Multifeeder Clutch
1) Remove the four screws, and detach the
rear cover; then, remove the two screws
[2], and disconnect the connector [3].
[1] [2]
[2] [3]
Figure 7-255
7-68
COPYRIGHT © 1999 CANON INC. CANON imageRUNNER 400/330 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
I. Vertical Path Assembly
Remove the vertical path assembly.
1) Remove the following:
• Inside cover
• Pick-up unit
• Pick-up drive unit
2) Remove the two rolls, and disconnect the
connector; then, detach the multifeeder
assembly.
3) Remove the two screws, and detach the
two positioning bosses [1] at the rear of
the copier.
[1]
Figure 7-256
4) Remove the varistor [2], positioning boss
[3], and bushing plate [4] (3 screws).
[3]
Figure 7-257
[2]
[4]