Canon imageRUNNER 330 Service Manual page 632

E. Finisher-C1
Code Detail code
E500
-
E503
0003
E504
0001
0002
0003
0004
E505
0001
E512
0001
0002
E530
0001
0002
COPYRIGHT © 1999 CANON INC.
Error
• Data communication error
• Communication error
• Height sensor (PS1)
• Back-Up RAM
• Delivery motor (M2)
• Delivery motor clock
sensor (PI10)
• Alignment motor (M3)
• Alignment plate home
position sensor (PI6)
• The fixing heater drive
circuit has a fault.
CANON imageRUNNER 400/330 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 14 TROUBLESHOOTING
Description
• The communication between the
copier and the finisher is
interrupted. This error is detected
by the copier.;
• The communication with the saddle
stitcher is interrupted.
• The communication between the
height sensor and the finisher
controller is not possible. Or, the
communication data has an error.
• The communication between the
sensor and the finisher controller
PCB is not possible for a specific
period or more.
• The disconnection of the sensor
connector is detected at time of
power-on.
• The sensor adjustment made by a
DIP switch has an error.
• The check sum has an error at
power-on.
• The number of clock pulses was
not obtained from the delivery
motor clock sensor at the start of
operation.
• The clock pulses stop for an
equivalent of 200 mm during
feeding operation.
• The alignment plate does not leave
the alignment home position sensor
after the alignment motor has been
driven for 2 sec.
• The alignment plate does not return
to the alignment plate home
position sensor after the alignment
motor has been driven for 2 sec.
14-233