Canon imageRUNNER 330 Service Manual page 208

3) Loosen the hex screw, and move the
horizontal registration plate to the rear/
font.
(front)
Horizontal
registration
plate
Figure 7-212
Caution:
When adjusting the horizontal registration
plate, try to match the inside of the L shape
against the appropriate gradation of the
scale.
+
Figure 7-213
COPYRIGHT © 1999 CANON INC. CANON imageRUNNER 400/330 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
(rear)
Hex
screw
-
CHAPTER 7 PICK-UP/FEEDING SYSTEM
B. Multifeeder
1. Removing the Multifeeder Unit
1) Remove the right cover.
2) Disconnect the connector [1].
Figure 7-214
3) Close the multifeeder, and open the right
door; then, pull out the rolls. (Both left
and right rolls are of the same shape.)
[2]
Figure 7-215
4) Pull the multifeeder to the front to remove.
Reference:
When mounting the multifeeder connector
cover, match its top an then push its bottom
from below.
[1]
Roll
7-55