Canon imageRUNNER 330 Service Manual page 287

7. Removing the Fixing Assembly
Outlet Sensor
1) Open the front door.
2) Open the delivery assembly.
3) Remove the fixing assembly.
4) Remove the four screws [3], and detach
the fixing assembly inlet sensor connector
cover [1] and the fixing assembly outlet
sensor [2] from the bottom of the fixing
assembly.
[8]
[9]
[9]
Figure 9-226
COPYRIGHT © 1999 CANON INC. CANON imageRUNNER 400/330 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[7]
CHAPTER 9 FIXING SYSTEM
8. Applying Lubricant
Apply heat-resisting grease (CK-0427) to
the parts shown.
[2]
Figure 9-227
• Engagement of the gears (on flat
teeth; heat-resisting grease)
• Edge of gears (lubricant)
• Engagement of gears of the fixing
assembly knob (heat-resisting grease)
[1]
9-23