APRILIA RSV 1000 R Factory Use And Maintenance Book page 20

1
MULTIFUNCTION COMPUTER
When the ignition key is set to position " ",
the following dashboard lights come on for
three seconds:
- all segments of the multifunction display;
- all warning lights;
- backlighting.
The rev counter pointer (1) moves to the
maximum rpm value set by the user. After
about three seconds, the red line light (2)
goes out and the rev counter pointer (1)
returns to its initial position.
During the initial check-up, all instruments will
briefly show the current values of the
corresponding parameters.
CAUTION
ERR
When an " " message flashes on the
d a s h b o a r d i n s t e a d o f t h e w a t e r
temperature and the stand and red line
lights stay on with a steady light, it means
that there is a communication problem on
the CAN line between dashboard and
Engine Control Unit. Contact a dealer.
use and maintenance RSV 1000 R - RSV 1000 R FACTORY
20
2
After covering the first 1000 km, the
" S E R V I C E " i c o n a p p e a r s o n t h e
multifunction display. The icon is
displayed again upon reaching 10,000
km and every 10,000 km afterwards.
Contact an
have the vehicle serviced as specified
in the periodic maintenance chart, see
page 63 (PERIODIC MAINTENANCE
CHART). To turn off the "SERVICE"
warning, hold down the "+" and "-"
buttons for at least 15 seconds upon
turning the key to on.
CAUTION
Official dealer to
aprilia
With the ignition key in position " ",
standard display readouts are as follows:
√ current speed
√ clock
√ coolant temperature
√ odometer.
TOGGLING BETWEEN MEASUREMENT
UNITS (km-mi, kph-MPH, °C-°F)
◆
Hold down the "TRIP/V" and "-" buttons
together for over 15 seconds to toggle
between km and mi and between kph
and MPH.
◆
Likewise, hold down the "TRIP/V" and
"+" buttons together for over 15 seconds
to toggle between °C and °F.