Card Cage Interconnect Board; Figure 8-34 Removing The Interconnect Board - Tektronix Phaser 440 Service Manual

8
FRU Disassembly/Assembly

Card cage interconnect board

8-42 Phaser 440 Color Printer
1.
Power down the printer. Leave the power cord plugged in to provide
a ground path for static discharges. Remove all interface cables.
2. Remove the left side, right side and top-rear cabinet panels. Refer to
the earlier topic "Printer cabinet panels" on page 8-4.
3. Remove the engine control board and the image processor board from
the card cage. Refer to the procedures "Engine control board" on
page 8-40 and "Image processor board" on page 8-44.
4. Remove the card cage and power supply assembly as explained in the
earlier procedure "Card cage and power supply" on page 8-36.
5. Remove the four screws securing the shield plate to the card cage.
6.
From underneath the card cage, remove the two screws securing the
interconnect board in place. Remove the board.
Reverse these steps to reinstall the interconnect circuit board.

Figure 8-34 Removing the interconnect board

8699-37