I/O Board; Figure 8-35 Removing The I/O Board - Tektronix Phaser 440 Service Manual

I/O board

Tools required
#1 POSIDRIV® screwdriver
1. Power down the printer. Leave the power cord plugged in to provide
a ground path for static discharges. Remove the interface cables.
2. Remove the top-rear and rear cabinet panels. Refer to the earlier topic
"Printer cabinet panels" on page 8-4.
3. Remove the screws securing the I/O board to the card cage.
4.
Disconnect the I/O board's ribbon cable(s) from the image processor
board. The Phaser 440 I/O board has two ribbon cables. Remove the
I/O board.
Reverse these steps to reinstall the I/O board and the image processor board.
I/O board
3

Figure 8-35 Removing the I/O board

FRU Disassembly/Assembly
4
Service Manual
8
9015-09
8-43