Transfer Roll Take-Up Motor; Figure 8-22 Removing The Transfer Roll Take-Up Gear - Tektronix Phaser 440 Service Manual

8
FRU Disassembly/Assembly

Transfer roll take-up motor

8-28 Phaser 440 Color Printer
Tools required
#1 POSIDRIV® screwdriver
1. Power down the printer and remove the power cord.
2.
Open the top access cover and remove the transfer roll.
3. Remove the left side cabinet panel. Refer to the earlier topic "Printer
cabinet panels" on page 8-4.
4.
On the inside of the printer, loosen the transfer roll take-up gear's two
set screws. Remove the gear.
Transfer roll
take-up
gear

Figure 8-22 Removing the transfer roll take-up gear

Gear,
reverse side
4
8699-47