Figure 8-23 Removing The Transfer Roll Take-Up Motor - Tektronix Phaser 440 Service Manual

5. On the outside of the printer, disconnect the wiring harness leading to
the transfer roll take-up motor.
6. Remove the two screws securing the transfer roll take-up motor to the
print engine frame. Remove the motor.
6

Figure 8-23 Removing the transfer roll take-up motor

Reverse these steps to reinstall the transfer roll take-up motor. When you install
the take-up gear, be sure to position the gear's set screw over the keyed portion
of the motor shaft.
Transfer roll
take-up motor
5
FRU Disassembly/Assembly
9015-39
Service Manual
8
8-29