Ethernet Card; Figure 8-38 Installing The Ethernet Card On The Image Processor Board - Tektronix Phaser 440 Service Manual

8
FRU Disassembly/Assembly

Ethernet card

8-46 Phaser 440 Color Printer
Tools required
#1 POSIDRIV® screwdriver
1. Power down the printer. Leave the power cord plugged in to provide
a ground path for static discharges. Remove the interface cables.
2. Remove the I/O board and the image processor board as explained in
the previous procedures "I/O board" on page 8-43 and "Image
processor board" on page 8-44.
3. Insert the Ethernet card in connector J30 (a), and tilt the card down
until it locks in place (b).
When properly inserted, a tab on each end of the connector slips into a hole on
each end of the card. Also, a pawl on each end of the connector latches around
each end of the card to lock it in place.

Figure 8-38 Installing the Ethernet card on the image processor board

4.
Reinstall the image processor and I/O board.
5. Reinstall the card cage top and the rear cabinet panels.
J30
Ethernet card
a b
9015-24