Tektronix Phaser 440 Service Manual page 45

The configuration page
Table 2-1 Configuration page settings
Parameter Description
Printer type The name of the product
Printer name The current name of the printer as
seen on a network
Pages printed Total number of prints processed
through the image processor
Startup page Indicates if the printer prints a startup
enabled page upon power-up
Ethernet A unique number for each
address Ethernet-capable printer
Authorization A unique number downloaded to the
code printer (in the field or at the factory) to
enable TCP/IP protocols
To provide further diagnostic information, the printer is able to print a
configuration page. The configuration page lists the values that the printer
stores in its NVRAM. These values can be informative when troubleshooting the
printer, particularly networked operations. A downloadable PostScript utility
file, found on the Drivers and Utilities diskette, allows you to print the
configuration page. You can also use the rear panel DIP switches to print one.
To print a configuration page, while the printer is powered-up and idle, toggle
rear panel Switch 4 up until printing starts and then down.
The configuration page gives you the following information:
General information about the printer, such as print count, the
programmed name, Ethernet address, the TCP/IP authorization code
(if loaded), timeouts, number of fonts, and total memory
Color settings such as Photofine enabled and Vivid Blue
Serial port settings
Parallel port settings
LocalTalk port settings
EtherTalk settings
TCP/IP settings
Novell NetWare settings
Installing the Printer and Drivers
Saved Default
in
NVRAM
yes Phaser 440
yes <printer name>
the default is the
same name of the
product
yes 0
yes No
yes Specific to each
Ethernet card. In
the format
xx:xx:xx:xx:xx:xx
yes 0000-0000-0000-
0000-0000-0000-
0000
Limits or alternate choices
Any name defined by the user
up to 31 characters in length
Yes or no
Valid code number
Service Manual
2
2-13