Connecting the Interface
Cable
■ Connecting to Staple Finisher-AN1/
Saddle Finisher-AN2/Finisher-W1/
Booklet Finisher-W1
NOTE:
For connecting the Interface Cable, refre to the
Finisher's Installation Procedure.
1. Connect the interface cable of this equipment to the
finisher.
1x
2. Install the wire saddle at the hole in the rear lower
cover.
NOTE:
The Wire Saddle is used to stow the cable of the finisher.
■ Connecting to Staple Finisher-X1 /
Booklet Finisher-X1
1. Remove the rear upper cover.
• 4 Screws
2. Disconnect the Interface Cable.
• 1 Connector
• 1 Guide
• 9 Wire Saddles
• 1 Edge Saddle
1x
11x
131
6. Installation
4x