Table of Contents
Advertisement
NXB-AP-1000 Interface – Initial Setup by Network Admin
System Requirements
Design Requirement
AMX highly recommends deploying only one NXB-AP-1000 Interface per system. Any configuration
violating this recommendation may not be backed by the technical support agreement. The
NXB-AP-1000 Interface offers a single, remote access point to a system, and its interactions with that
system can cause interference and collision issues if more than one NXB-AP-1000 Interface is present.
Note: The instructions in this chapter assume that all of the AMX AutoPatch devices in the system
are connected and powered up.
Opening the NXB-AP-1000 Interface
Caution: We strongly recommend that the NXB-AP-1000 Interface site be placed inside your
network firewall and that system security be turned on.
A worksheet to record connection information is provided at the end of this chapter (see page 91).
To set up the NXB-AP-1000 Interface:
1.
Follow the directions on page 40 for connecting the TCP/IP connector on the Epica DGX 32
enclosure's CPU to a LAN or to a network card in a PC.
2.
Launch a browser on your PC.
3.
Type the IP address (as determined on page 80) in the address bar of the browser and press Enter.
The PC must be on the same subnet (e.g., 192.168.X.X).
The NXB-AP-1000 Interface Home page opens. The Home page contains system configuration
information.
4.
Complete any necessary configuration of the NXB-AP-1000 Interface. Instructions are included in
this chapter.
If the Home page does not open, see the "NXB-AP-1000 Troubleshooting" section on page 43.
78
Web browser (Internet Explorer, Firefox, Netscape, etc.)
JRE v1.4.x or greater (Java Plug-in for the XBar Controller)
Epica DGX 32 Instruction Manual
Advertisement
Table of Contents
