Table of Contents
Advertisement
Navigating the NXB-AP-1000 Interface
The NXB-AP-1000 Interface has two drop down menus: IP Control and Admin. These menus access all
the control, configuration, preferences, and settings pages in the interface. The menu options are shown
in FIG. 35 and FIG. 36. In addition, some pages have tab options as well (see FIG. 37 on page 80).
IP Control Menu - Options for the IP Control Pages in the Interface
FIG. 35
IP Control drop down menu options
Admin Menu - Options for the Configuration Manager Pages in the Interface
Admin drop down menu options
FIG. 36
Configuring a Connection to a NetLinx Master
One of the main features of the NXB-AP-1000 Interface is that it allows you to make various
configuration settings via a web browser on any PC, including those with access to a NetLinx Master.
Important: DHCP must be enabled in order for the zero-configuration client (e.g., Bonjour for
Windows) to detect the Epica DGX 32 on the network. To enable DHCP, select Admin menu / IP
Settings and check DHCP.
Accessing the Epica DGX 32 via Zero-Config
NetLinx Studio version 3.0 (or higher) features a "Zero-Config" tab in the Workspace Window. This tab
provides Zero-Config networking functionality within NetLinx Studio. Refer to the NetLinx Studio
online help for additional details on using Zero-Config.
Assuming that the Epica DGX 32 resides on the same LAN as the PC running NetLinx Studio and the
NetLinx Master to which the matrix switcher is connected, you can access the Epica DGX 32 via the
Zero-Config feature in NetLinx Studio.
Epica DGX 32 Instruction Manual
NXB-AP-1000 Interface – Initial Setup by Network Admin
79
Advertisement
Table of Contents
