Appendix D - Programmer's Interface For System Diagnostics; System Component Information - AMX Epica DGX 32 Instruction Manual

Appendix D – Programmer's Interface
for System Diagnostics

System Component Information

The Epica DGX 32 displays system information in its splash screen* for diagnostic purposes. The
information indicates the current status and well-being of the system components.
~scr!
[1:Enclosure] AMX AutoPatch Epica DGX 32
[2:Storage Blocks] cleared
[3:Communication Interfaces] count = 3
[4:Hardware Boards] detected
[5:VM Configuration] count = 1
[6:Power System] good
[7:System Sensors] detected
Example of a default Epica DGX 32 splash screen
FIG. 1
The splash screen can be accessed using a terminal emulation program, such as HyperTerminal
(see page 27). One of four verbosity** settings is specified, which provides either a list of the seven
system components with minimal information (FIG. 1) or a level of detailed information on one of the
seven components. Only one verbosity setting and one component setting can be entered in a command.
The order in which the verbosity and component settings are entered is interchangeable.
Note: In a multiple-enclosure system, the splash screen displays information only for the enclosure
that is connected directly to the PC.
* AMX reserves the right to add to the contents of the splash screen at any time, without notice.
** Verbosity (i.e., wordiness) refers to the amount of information provided; the higher the verbosity
setting, the more information is displayed.
Epica DGX 32 Instruction Manual
Appendix D – Programmer's Interface for System Diagnostics
Command entered to display minimal information
for all system components
The system's component identity numbers are
to the left of each component
133