Executing Local Presets - AMX Epica DGX 32 Instruction Manual

Executing Local Presets

A local preset is a predetermined set of switches on a particular virtual matrix that are routed
simultaneously. They are stored in each enclosure's configuration file and can be executed at any time.
Local Preset will not appear as a submenu option in the Function menu if local presets have not already
been defined. In addition, they will not appear if the system is on a virtual matrix that does not have local
presets. The Epica DGX supports 335 local presets.
Local presets are not programmed (defined) at the factory. To program them, use XNConnect
configuration software (see page 116) or contact your AMX representative (for contact information, see
page 40). Once the local presets have been defined as part of the configuration file, the new file must be
loaded to the system's CPU (see page 118) and reloaded to the control panel (see page 73).
Make sure the control panel is switching on the virtual matrix where the local preset resides. If no local
presets have been defined for the selected VM, the Local Preset submenu option will not be available on
the Function menu.
Note: Executing a local preset does not change any system routings that are not part of the preset.
The example below executes Local Preset 3 "Discon Conf Rm B" on VM 0.
To execute a local preset:
1.
Press the Function Key.
The Function menu appears.
2.
Locate Local Preset by scrolling with the Control Dial.
3. Press the Select Key.
The Local Preset list appears.
4. Scroll to Local Preset 3.
5.
Press either the Select Key or the Take Key.
Local Preset 3 is executed.
6. Execute another local preset.
Or
Press the Function Key to return to the Function menu.
Epica DGX 32 Instruction Manual
Control Panel Operation
65