Specifications Epica Dg Mtp ® Fiber (& Epica Dg Dvi) - AMX Epica DG Instruction Manual

®
Epica DG MTP Fiber Boards
Specifications Epica DG MTP
Applies to input board FG1055-410 and output board FG1055-413.
Compatible AMX AutoPatch modules: DG RGBHV MTP
and RX.
Epica DG MTP
Parameter
Resolution Support
Fiber Cable Types
Fiber Cable Length
Fiber Cable Termination
Fiber Connector (on board)
*3,000 ft. cable requires low loss, controlled skew fiber cable, such as, Alcoa 50/125 μm Laser-Link 550.
Epica DG DVI Specifications
Parameter
Pixel Bandwidth (bit rate)
Resolution Support
Specification Compliant
Input Cable Equalization
DDC/EDID Support
HDCP Supported
Reclocking (output)
Connector Types
EDID Resolutions Supported through Local DDC**
1920x1200 (uses reduced sync blanking) 1600x1200
1920x1080 (uses reduced sync blanking) 1280x1024
1680x1050
** Additional resolutions may be supported through local DDC.
AMX reserves the right to modify its products and their specifications without notice.
46
®
Fiber Specifications
Up to 1920x1200 @ 60 Hz refresh rate (with reduced sync blanking)
12-fiber multi-mode MTP, 50/125 μm (recommended) or 62.5/125 μm
Up to 3000 ft. (914.4 m) in and 3000 ft. (914.4 m) out*
®
Female MTP
®
Male MTP /MPO fiber (guide pins define it as a male)
1.65 Gbps
Up to 1920x1200 @ 60 Hz refresh rate (with reduced sync blanking)
DVI 1.0, DVI-D single link
Up to 50 ft. (15.24 m)
EDID resolution provided by the Epica DG
No
Yes
DVI-I, use with DVI-I or DVI-D cables (DVI-D is the supported signal type)
Resolutions
1280x768
®
Fiber (& Epica DG DVI)
®
Fiber RX and TX, DG DVI MTP
Value
Value
1280x720 800x600
1152x864 640x480
1024x768 –
Epica DG Instruction Manual
®
Fiber TX