Table of Contents
Advertisement
Setting a Static IP Address
The current IP address is displayed on the IP Settings page.
IP Settings page
FIG. 39
To enter a static IP address:
1.
From the Admin drop down menu, select IP Settings.
2.
If DHCP is selected, click to disable.
3.
Enter the static IP address in the IP Address field.
4.
Click Accept.
5.
Click Reboot.
Important: Any time you click "Reboot" from any page in the NXB-AP-1000 Interface, the server
reboots. The reboot updates information between the Epica DGX 32 and the server.
(The Epica DGX 32 system itself does not reboot).
Using a DHCP IP Address (Optional)
The NXB-AP-1000 Interface offers the option of using a DHCP (Dynamic Host Configuration Protocol)
IP address (must be on a network that contains a DHCP server). The settings on the IP settings page will
typically be for a fixed or static IP address.
To force invocation of a DHCP IP address:
1.
From the Admin drop down menu, select IP Settings.
2.
If DHCP is not selected, click to enable.
3.
Click Accept.
4.
Click Reboot. The NXB-AP-1000 Interface begins searching for a DHCP server.
If the search times out, the address will revert to the original IP address.
(If the computer is on the same subnet, use the AutoUpdate.exe program on the AMX AutoPatch CD
to see the IP address to connect to.)
Important: Any time you click "Reboot" from any page in the NXB-AP-1000 Interface, the server
reboots. The reboot updates information between the Epica DGX 32 and the server.
(The Epica DGX 32 system itself does not reboot).
Epica DGX 32 Instruction Manual
NXB-AP-1000 Interface – Initial Setup by Network Admin
83
Advertisement
Table of Contents
