Rrp1.4 Cover Top (Pl 1.1), Operation Panel (Pl 1.1) - Oki B6500 Service Manual

RRP1.4 COVER TOP (PL 1.1), OPERATION PANEL (PL 1.1)
Removal
1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).
2) Remove the COVER REAR (PL 1.1) (RRP1.1).
3) Remove the COVER RIGHT (PL 1.1) (RRP1.2).
4) Remove the COVER LEFT (PL 1.1) (RRP1.3).
5) Remove the COVER EXIT 500 (PL 1.1) (RRP7.1)
6) Remove the 500 EXIT ASSEMBLY (PL 7.1) (RRP7.2).
7) Remove the 2 screws (silver with flange, 8mm) securing the COVER TOP to the printer (Figure 1).
8) Remove the LEVER LINK (PL 6.1) from the boss of the COVER OPEN (PL 1.1) (Figure 1).
When removing the LEVER LINK from the boss of the COVER OPEN, the cover is
opened, and the LEVER LINK is extended (Figure 1).
In the following steps, do not separate the COVER TOP too far from the printer, since the
OPERATION PANEL (PL 1.1) attached to the COVER TOP is connected to the printer.
9) Release the 2 hooks securing the front of the COVER TOP to the COVER FRONT (PL 1.1), and
pull out the COVER TOP slightly away from the printer.
10) Disconnect the connector (P/J1) of the OPERATION PANEL.
11) Release the harness clamps of the OPERATION PANEL.
12) Remove the COVER TOP.
13) Release the 2 hooks securing the OPERATION PANEL to the COVER TOP, and remove the
OPERATION PANEL.
Chapter 3 Removal and Replacement Procedures (RRPs)
OPERATION PANEL
(PL1.1.1)
Figure 1. Top Cover & Operation Panel
COVER OPEN
(PL1.1.2)
3 - 7
J23146AA