Rrp4.1 150 Feeder Assembly (Pl) - Oki B6500 Service Manual

RRP4.1 150 FEEDER ASSEMBLY (PL 4.1)
Removal
1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).
2) Remove the FUSER ASSEMBLY (PL 6.1) (RRP6.8).
3) Remove the COVER REAR (PL 1.1) (RRP1.1).
4) Remove the CHUTE TRANSFER (PL 6.1) together with the BTR ASSEMBLY (RRP6.9).
5) Disconnect the connector (P/J245) of the HARNESS ASSEMBLY TRAY 1 (PL 4.1) from the HAR-
NESS ASSEMBLY CHUTE (PL 9.1) (Figure 1).
6) Disconnect the connector (P/J221) of the HARNESS ASSEMBLY TONER 1 (PL 4.1) from the
HARNESS ASSEMBLY TONER 2 (PL 9.1.28) (Figure 1).
7) Remove the 5 screws (silver with flange, 8mm) securing the 150 FEEDER ASSEMBLY to the
printer (Figure 1).
8) Shift the 150 FEEDER ASSEMBLY backward, and remove the right boss of the 150 FEEDER
ASSEMBLY from the frame.
9) Lift up the 150 FEEDER ASSEMBLY in the direction of the arrow (A), and remove the left boss of
the 150 FEEDER ASSEMBLY.
The 150 FEEDER ASSEMBLY clicks into a notch when lifted to the half way point, push
the assembly past the notch.
Remove the 150 FEEDER ASSEMBLY from the printer.
Chapter 3 Removal and Replacement Procedures (RRPs)
Figure 1. Feeder Assembly
3 - 57