Operation Panel - Oki IP-6620 User Manual

Operation panel

The buttons, LEDs and LCD are placed on the printer's operation panel as shown below. In addition, the operation
panel is also equipped with a buzzer to draw attention in case an error occurs or an invalid button is pressed.
The printer enters waiting mode if it is not used for a given length of time.
LED
ON, blinking and OFF indicate the
status of the printer.
Refer to the table below.
LCD
Shows the status of the printer and
displays the menu window (2 rows, 20
characters).
Waiting mode
(During waiting mode)
LCD: Display and backlight turned off
Online LED: Flashes slowly
Other LEDs: Off
(Exiting waiting mode)
The printer exits waiting mode when
- any button is pressed,
- the printer receives print data.
Buzzer
Sounds when an error occurs or an
invalid button is pressed, and warns of
daily maintenance and when the print
heads are uncapped.
LED
Indicates whether an error has occurred.
ON: An error has occurred.
Blink: Warning state.
Error LED (Orange)
OFF: Normal (no error)
Indicates the status of the media heater.
- ON: The set temperature has been reached
Media heater LED
- Blink: Currently heating
(Green)
- OFF: Media heater is off
Indicates whether ink is remaining.
ON: Ink for all colors is present.
Blink: Ink near-end (The level of any color is low.)
Ink LED (Green)
OFF: No ink.
Indicates the online, offline, data reception, and
pause status.
ONLINE LED (Green)
- ON: Online
- Blink (slowly): In pause
- Blink (fast): Data reception
- OFF: Offline
SET
ORIGIN
CANCEL ONLINE
HEATER MENU
ADJUST MAINTENANCE
NOZZLE PRINT PH.RECOVERY
POWER
CANCEL
ONLINE
HEATER
MENU
ADJUST
MAINTENANCE
NOZZLE PRINT
PH.RECOVERY
Up, Down, Left, Right buttons
Used to select menu options, switch
between menus (selection, increasing/
decreasing values), etc.
OK button
Used to confirm the menu and
parameters.
Buttons
Use these buttons to operate the menu
of the printer.
Refer to the table below.
Power switch
Used to turn on or off the power of the
printer.
Used to manually enter and exit waiting
mode.
Buttons
Cancels entered parameters or returns back to the upper
menu.
Switches between online and offline states, and puts the
printer in pause or resumes printing.
Enters heater control menu.
Used to display information about the printer and change
printer settings.
Used to enter the adjustment menu.
Used to enter the maintenance menu.
Used to perform a nozzle print.
Used to enter the cleaning menu.
Before printing
29