Rrp4.7 Sensor Regi (Pl 4.1.30) - Oki B6500 Service Manual

RRP4.7 SENSOR REGI (PL 4.1.30)
Removal
1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).
2) Remove the COVER REAR (PL 1.1) (RRP1.1).
3) Release the hooks securing the COVER SENSOR (PL 4.1), and remove the COVER SENSOR
from the CHUTE ASSEMBLY REGI (Figure 1).
4) Release the hooks securing the SENSOR REGI, and remove the SENSOR REGI from the
COVER SENSOR (Figure 1).
5) Disconnect the connector (P/J241) of the HARNESS ASSEMBLY TRAY 1 (PL 4.1) from the SEN-
SOR REGI.
Replacement
1) Connect the connector (P/J241) of the HARNESS ASSEMBLY TRAY 1 (PL 4.1) to the SENSOR
REGI.
2) Install the SENSOR REGI to the COVER SENSOR (PL 4.1), and secure it using hooks (Figure 1).
3) Install the COVER SENSOR to the CHUTE ASSEMBLY REGI, and secure it using hooks (Figure
1).
4) Install the COVER REAR (PL 1.1) (RRP1.1)
There are 2 kinds of screws, make sure they are installed correctly.
5) Install the COVER REAR 500 (PL 7.1) (RRP7.9).
Chapter 3 Removal and Replacement Procedures (RRPs)
Figure 1. Registration Sensor
3 - 67