Fip1.8 Paper Jam/Exit - Oki B6500 Service Manual

FIP1.8 Paper Jam/Exit

Step
Possible causes:
FUSER ASSY (PL8.1.20)
HVPS/MCU (PL12.1.19)
HARNESS ASSY FUSER (PL8.1.17)
MOTOR ASSY EXIT (PL10.1.15)
LVPS (PL12.1.5)
ROLL PINCH EXIT (PL10.1.23)
500 EXIT ASSY (PL10.1.2)
150 PAPER CASSETTE (PL2.1.50)
550 PAPER CASSETTE (PL4.1.50)
Checking the paper condition.
1
Is the paper crumpled, damaged or damp?
Checking the paper size setup.
2 Does the paper size in use match the size setup by
GUIDE ASSY END or by the driver on the PC?
3 Does Error occur when the power is turned ON?
Checking the paper in Actuator Exit.
4
Is there any remaining paper in Actuator Exit?
5 Does Error occur when the power is turned ON?
Run a test print.
Does Error occur?
6
Check using Chapter 2 Diagnostic [TEST PATTERN
MODE MENU].
Checking ROLL PINCH EXIT.
Remove COVER TOP ASSY (PL1.1.7). (RRP1.4)
Is ROLL PINCH EXIT not damaged, and rotating
7
smoothly?
Does SPRING PINCH EXIT attach?
Turn ROLL EXIT with a finger to check.
Checking ROLL EXIT (PL10.1.12) for rotation.
Remove EP CARTRIDGE.
8 Close COVER OPEN (PL1.1.2).
Turn the power ON.
Does ROLL EXIT rotate smoothly during warm up?
Checking Actuator Exit for operation.
Remove EP CARTRIDGE.
9 Does Actuator Exit move smoothly, when touching
Actuator Exit with a finger inserted from the exit of
FUSER ASSY, and moving it up and down?
Checking Exit Sensor for operation (1).
Remove EP CARTRIDGE.
Does the number of Sensor/Switch Check increase by
10
one, every time Actuator Exit is pushed and released?
Check using Chapter 2 Diagnostic [Sensor/Switch
Check].
Check
1 – 20
Chapter 1 Troubleshooting
Yes
Replace the
paper with a new Go to step 2.
and dry one.
Replace the paper,
Go to step 3. or set up the paper
size correctly.
Go to step 4. Go to step 6.
Remove the
paper, and go to Go to step 8.
step 5.
Go to step 8. Go to step 6.
Go to step 7. End of work
Replace ROLL
Go to step 8.
PINCH EXIT.
500 EXIT ASSY.
Go to step 9.
With tool Go to
step 10. Without Replace FUSER
tool Go to step ASSY. (RRP8.8)
11.
Replace HVPS/
MCU. Go to step 11.
(RRP12.10)
No
(RRP10.2)