Fip3.10 Motor Assy Offset - Oki B6500 Service Manual

FIP3.10 MOTOR ASSY OFFSET

Step
Possible causes:
MOTOR ASSY OFFSET (PL23.1.20)
MOTOR ASSY OCT (PL23.1.6)
PWBA OCT (PL23.1.22)
HARNESS ASSY OCT2 (PL23.1.25)
HVPS/MCU (PL12.1.19)
HARNESS ASSY OCT1 (PL12.1.26)
Checking MOTOR ASSY OFFSET
Not using DIAG tool: Replace MOTOR ASSY OFF-
SET.(RRP23.8)
1
Is the problem cleared?
Using DIAG tool: Does the offset of CHUTE OFFSET
ASSY operate normally?
Check using Chapter 2 Diagnostic [OCT Offset Test].
2 Is the problem cleared?
Checking MOTOR ASSY OFFSET
3 Replace MOTOR ASSY OFFSET. (RRP23.8)
Is the problem cleared?
Checking HARNESS ASSY OCT2 for continuity
Disconnect P/J70 from PWBA OCT.
4
Remove HARNESS ASSY OCT2.
Is there continuity between J70 and J3070?
Checking HARNESS ASSY OCT1 for continuity
5 Remove HARNESS ASSY OCT1.
Is there continuity between J30 and J3070?
Checking PWBA OCT
6 Replace PWBA OCT. (RRP23.7)
Is the problem cleared?
Check
1 – 91
Chapter 1 Troubleshooting
Yes
End of work Go to step 4.
Go to step 2. Go to step 3.
Go to FIP3.8
End of work
PWBA OCT.
End of work Go to step 4.
Replace HAR-
Go to step 5. NESS ASSY
Replace HAR-
Go to step 6 NESS ASSY
Replace HVPS/
End of work
MCU. (RRP12.10)
No
OCT2.
OCT1.