Counter Mode; Setting; Description (Mm) - Minolta Di152 Service Manual

(4)

Counter Mode

• Shows the number of copies made on each paper size or type.
<Procedure>
1. Enter the code number corresponding to the function to be used from the 10-Key Pad.
2. Press the Start key to show the count.
If the count consists of 4 or more digits, it is displayed in two groups alternately as fol-
lows.
E.g.: "123" and "456" alternate if the count is 123,456.
3. Press the Paper key to select the display of another counter.
4. Call the counter count to be cleared on the Display.
5. Press the Clear Key.
Press Interrupt key to undo the clearing operation, restoring the original setting.
6. Press the Start Key.
<Exiting the Mode>
• Press the Panel Reset key until the initial screen reappears.
Code No.
Counts the frequency of use of each of the different parts of the
copier.
The count should be cleared when the corresponding PM part is
replaced.
--1
Enter a value for the maintenance counter (for any given part).
The count is based on a countdown system and when the set value is
counted down to "0," the Maintenance Indicator lights.
If counting continues after "0," a minus sign (-) is appended to the
value shown on the Display.
NOTE
• The above counting method varies depending on the setting made
--2
<Procedure>
1. Press the Start key to display the current count.
2. Press the Clear key to clear the current count.
3. Enter the new value from the 10-Key Pad (that can range from 0 to
4. Press the Start key to validate the new setting just made.
Display Description
1 Bypass Tray
2 1st Tray
3 2nd Tray
4 3rd Tray
5 4th Tray
for "c-1" of Tech. Rep. Choice.
The Display shows "nc1" if copying is prohibited.
If the current count is mistakenly cleared, press the Interrupt key
to restore the count just cleared.
999999).
S-18

Setting

<PM Counter>
Display
6 5th Tray
7 ADF
8 IR
9 Ozone Filter
10 Image Transfer Roller/Fusing Unit
<Maintenance Counter>
Description