Removal Of The Control Board; Removal Of The High Voltage Unit - Minolta Di152 Service Manual

(2)

Removal of the Control Board

1. Remove the Rear Cover.
2. Remove the PWB Cover Assy.
(3)

Removal of the High Voltage Unit

1. Remove the control panel, Front Cover, Rear Cover, Left Cover, Upper Cover, Right
Inside Cover, and Rear Inside Cover.
2. Remove the PWB Cover Assy.
3. Unplug all connectors from the Master Board (except for PJ20) and from the Control
Board.
4. Remove the harness from seven wiring saddles and two edge covers.
3. Unplug all connectors (but PJ20) from the Master
Board.
4. Remove four screws and the Master Board.
3. Unplug all connectors from the Control Board.
4. Remove six screws and the Control Board.
D-11