JBL SYNTHESIS SDP-40 User Manual page 85

SETUP
On-Screen Display
(continued from page 3-44)
POSITION
SETUP DISPLAYS ON-SCREEN DISPLAY
Controls the vertical alignment of the two-line status on the display
device screen. When TOP is selected, the two-line status appears
near the top of the display device screen. When CENTER is selected,
the two-line status appears centered on the display device screen.
When BOTTOM is selected, the two-line status appears near the
bottom of the display device screen.
FORMAT
SETUP DISPLAYS ON-SCREEN DISPLAY
Controls the compatibility between the composite and S-video
output connectors, the video switcher, and the display device.
Select the setting that is compatible with the source components
and the display device.
Note:
The FORMAT parameter has no effect on the
component video output connector.
BACKGROUND
SETUP DISPLAYS ON-SCREEN DISPLAY
Determines the on-screen display background. When ON is selected,
the on-screen display appears over a solid blue or gray background
(depending on the display device). When OFF is selected, the on-
screen display appears over the video input signal.
3-45
TOP, CENTER, BOTTOM
POSITION
SECAM, PAL, NTSC
FORMAT
ON, OFF
BACKGROUND
Note:
When the BACKGROUND parameter is set to OFF, the
on-screen display automatically deactivates when the
display device is connected to the Main Zone
component video output connector.
REMOTE STATE
SETUP DISPLAYS ON-SCREEN DISPLAY
Activates the remote control command bank indicator, a letter that
appears in the top-right corner of the on-screen display to indicate
the command bank from which the SDP-40 last received a
command. The table below indicates the letter that represents each
command bank.
When ON is selected, the command bank indicator appears in the
top-right corner of the on-screen display whenever the SDP-40
receives a remote control command. When OFF is selected, the
command bank indicator does not appear on the on-screen display
when the SDP-40 receives a remote control command.
Letter Indicator Command Bank
None* Main Zone
Z Zone 2
R Record Zone
S Shift
* No letter appears when the SDP-40 receives a command from the Main Zone
command bank, even if the REMOTE STATE parameter is set to ON.
JBL
ON, OFF
REMOTE STATE