Edit Custom Name - JBL SYNTHESIS SDP-40 User Manual

SDP-40
ON-SCREEN DISPLAY
SETUP DISPLAYS ON-SCREEN DISPLAY
Selecting the DISPLAY SETUP menu ON-SCREEN DISPLAY option opens the ON-SCREEN DISPLAY menu shown below, which can be used to
customize the on-screen display.
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
SETUP
Default
Parameter Setting
STATUS 2 SECONDS
POSITION TOP
FORMAT NTSC
BACKGROUND ON
REMOTE STATE ON
STATUS
ALWAYS ON, 2 SECONDS, ALWAYS OFF
SETUP DISPLAYS ON-SCREEN DISPLAY
Controls the activation of the on-screen display when the display
device is connected to a Main Zone video output connector. When
ALWAYS ON is selected, the on-screen display remains activated at
SETUP DISPLAY SETUP
INPUTS ON-SCREEN DISPLAY ON-SCREEN DISPLAY
SPEAKERS FRONT PANEL DISPLAY
REAR PANEL CONFIG A/V SYNC DELAY
DISPLAYS DISPLAYS CUSTOM NAME
VOLUME CONTROLS

EDIT CUSTOM NAME

TRIGGERS
LOCK OPTIONS
Possible
Settings
ALWAYS ON, 2 SECONDS,
ALWAYS OFF
TOP, CENTER, BOTTOM
SECAM, PAL, NTSC
ON, OFF
ON, OFF
STATUS
ON-SCREEN DISPLAY
STATUS 2 SECONDS
POSITION TOP
OFF FORMAT NTSC
OFF BACKGROUND ON
REMOTE STATE ON
ON
OFF
all times. When 2 SECONDS is selected, the on-screen display
activates for two seconds whenever a new input source is present
or a new command is received. When ALWAYS OFF is selected, the
on-screen display remains deactivated at all times, and will not
reactivate until the STATUS parameter is reset to ALWAYS ON or 2
SECONDS.
Note:
When the ON-SCREEN DISPLAY menu STATUS
parameter is set to ALWAYS OFF, the on-screen display
immediately deactivates. Press the OSD button or use
the front panel display as a guide to reset the
ON-SCREEN DISPLAY menu STATUS parameter to
ALWAYS ON or 2 SECONDS.
SETUP
ALWAYS ON
2 SECONDS
ALWAYS OFF
TOP
CENTER
BOTTOM
SECAM
PAL
NTSC
. . . On-Screen Display continues on page 3-45
3-44