JBL SYNTHESIS SDP-40 User Manual page 65

SDP-40
Speaker Setup Parameters
SETUP SPEAKERS SET CROSSOVERS
The table below indicates the speaker setup parameters that can be
used to configure the Main Zone audio output connectors for the
desired speaker setup. These parameters appear on the CUSTOM
and SYNTHESIS 7CH SETUP menus.
Parameter
FRONT L/R*
CENTER*
SIDE L/R*
REAR L/R
SUB L/R*
SUB XOVER*
LFE*
ULTRA2 SUB
BGC
ASA
* These parameters cannot be adjusted on the SYNTHESIS 7CH SETUP menu.
† When the ULTRA2 SUB parameter is set to OFF, the BGC parameter is not available (N/A).
CUSTOM SETUP OR SETUP
CUSTOM SETUP Menu
Default Setting
80Hz FULL, 30 to 120Hz, THX 80Hz
80Hz FULL, 30 to 120Hz, THX 80Hz, NONE
80Hz FULL, 30 to 120Hz, THX 80Hz, NONE
80Hz FULL, 30 to 120Hz, THX 80Hz, NONE
80Hz MONO, STEREO, NONE
80Hz FULL, 30 to 120Hz, THX 80Hz
ON ON, OFF
OFF ON, OFF
N/A† ON, OFF
APART APART, CLOSE, TOGETHER
SPEAKERS SET CROSSOVERS
Speaker setup parameters perform the same function regardless of
which speaker setup is selected. When a parameter setting is
adjusted on one menu, the corresponding parameter setting is
automatically adjusted on the other menu. For instance, when a
SYNTHESIS 7CH speaker setup is selected, the speaker setup
parameters on the CUSTOM SETUP menu are also set to 80Hz.
Possible Settings
SYNTHESIS 7CH SETUP
SYNTHESIS 7CH SETUP Menu
Default Setting Possible Settings
80Hz 80Hz
80Hz 80Hz
80Hz 80Hz
80Hz 80Hz, NONE
80Hz 80 Hz
80Hz 80Hz
ON ON, OFF
OFF ON, OFF
N/A† ON, OFF
APART APART, CLOSE, TOGETHER
. . . Setting Crossover Points continues on page 3-26
SETUP
3-25