JBL SYNTHESIS SDP-40 User Manual page 115

SDP-40
5.1 ULTRA2, 5.1
MODE ADJUST 5.1 @** ULTRA2 OR
Listening mode name differs depending on the encoding present
in the input source, the SURROUND EX parameter setting, and the
speaker setup. The table below indicates the conditions in which
THX Ultra2 and THX Surround EX decoding are engaged.
• The 5.1 ULTRA2 listening mode is available when THX
Ultra2 decoding is engaged.
• THX Ultra2 decoding is engaged when the SURROUND EX
parameter is set to OFF or when the SURROUND EX parameter
is set to AUTO and a non-flagged 5.1-channel Dolby Digital
source with or without THX Surround EX encoding is detected.
• The 5.1 SurEX listening mode is available when THX
Surround EX decoding is engaged.
• THX Surround EX decoding is engaged when the SURROUND
EX parameter is set to ON or when the SURROUND EX
parameter is set to AUTO and a flagged 5.1-channel Dolby
Digital source with THX Surround EX encoding is detected.
Input Source
Parameter Setting
SURROUND EX: AUTO
SURROUND EX: ON
SURROUND EX: OFF
SurEX, & 5.1
5.1 @** SurEX OR 5.1 @**
5.1-Channel
Dolby Digital
5.1 ULTRA2
5.1 SurEX
5.1 ULTRA2
• The 5.1 Ultra2 and 5.1
available unless both side and rear speakers are present.
• The 5.1 listening mode is available when neither THX
Ultra2 nor THX Surround EX decoding is engaged.
Note:
The SDP-40 cannot automatically detect THX
Surround EX encoding in non-flagged 5.1-channel
Dolby Digital sources. A non-flagged input source
does not include information in the input signal that
identifies THX Surround EX encoding.
5.1-Channel
THX Surround EX
Dolby Digital (Flagged)
5.1 SurEX
5.1 SurEX
5.1 ULTRA2
. . . 5.1 ULTRA2, 5.1
MODE ADJUST
SurEX listening modes are not
5.1-Channel
THX Surround EX
Dolby Digital (Non-Flagged)
5.1 ULTRA2
5.1 SurEX
5.1 ULTRA2
SurEX, & 5.1 continues on page 5-18
5-17