Table of Contents
Advertisement
Command Line Interface (CLI)
Set VLAN/SSID Parameters
Enable VLAN Management
[Device-Name]>set vlanstatus enable
[Device-Name]>set vlanmgmtid <1-4094>
[Device-Name]>show vlandidtbl (to review your settings)
[Device-Name]>reboot 0
Disable VLAN Management
[Device-Name]>set vlanstatus disable or
[Device-Name]>set vlanmgmtid 0
[Device-Name]>reboot 0
Add an Entry to the VLAN ID Table
[Device-Name]>set vlanidtbl <index number; see table> id <1-4094, -1=untagged> ssid <enter network
name>
[Device-Name]>show vlandidtbl (to review your settings)
[Device-Name]>reboot 0
NOTE
16 VLAN/SSID pairs are available for 802.11b/g AP Cards only.
CLI Monitoring Parameters
Using the show command with the following table parameters will display operating statistics for the AP (these are the
same statistics that are described in
–
staticmp: Displays the ICMP Statistics.
–
statarptbl: Displays the IP ARP Table Statistics.
–
statbridgetbl: Displays the Learn Table.
–
statiapp: Displays the IAPP Statistics.
–
statradius: Displays the RADIUS Authentication Statistics.
–
statif: Displays information and statistics about the Ethernet and wireless interfaces.
–
stat802.11: Displays additional statistics for the wireless interfaces.
–
statethernet: Displays additional statistics for the Ethernet interface.
–
statmss: Displays station statistics and Wireless Distribution System links.
Parameter Tables
Objects contain groups that contain both parameters and parameter tables. Use the following tables to configure the
Access Point. Columns used on the tables include:
— Name - Parameter, Group, or Table Name
— Type - Data type
— Values - Value range, and default value, if any
— Access = access type, R = Read Only (show), RW = Read-Write (can be "set"), W = Write Only
— CLI Parameter - Parameter name as used in the Access Point
Access Point network objects are associated with groups. The network objects are listed below and associated
parameters are described in the following Parameter Tables:
•
System Parameters
–
Inventory Management Information
•
Network Parameters
–
IP Configuration Parameters
—
DNS Client for RADIUS Name Resolution
Monitor Information
- Access Point system information
- Hardware, firmware, and software version information
- IP and Network Settings
- Configure the Access Point's IP settings
for the HTTP Web interface).
- Configure the Access Point as a DNS client
C-24
Advertisement
Table of Contents
