Before You Begin - HP 650 Series Installation Manual

Figure 7 650 Series USB
Reset Button
The reset button located on the bottom of the device can be used to reset the access point to factory default
settings or turn off/on the LED display.
Use one of the following methods to reset the access point to factory default settings:
To reset during normal operation:
n
Hold the reset button for more than 10 seconds while the access point is running.
l
Release the reset button.
l
To reset during power up, hold the reset button while the access point is powering up.
n
The system status LED will flash again within 15 seconds indicating that the reset is completed. The access
point will now continue to boot with the factory default settings.
To toggle the LED display between Off and Blinking, during the normal operation of the access point, shortly
press and release the reset button using a small, narrow object, such as a paperclip.
Power
Both Ethernet ports support PoE-in, allowing the AP to draw power from an 802.3at/802.3bt PoE power
source|PoE input rating is 57V max|0.3A. 0.3A is per pair of wires in Ethernet cable. Ethernet cable has 4 pair
of wires totally." When the AP is powered by both E0 and E1 ports simultaneously, the AP can be configured by
management software to source PoE power from either port, or to combine power from both ports an 802.3af
source may be used.
PoE input rating is 57V max | 3.0A is per pair of wires in Ethernet cable. Ethernet cable has 4 pair of wires totally.

Before You Begin

Refer to the sections below before beginning the installation process
FCC Statement: Improper termination of access points installed in the United States configured to non-US model con-
trollers will be in violation of the FCC grant of equipment authorization. Any such willful or intentional violation may res-
ult in a requirement by the FCC for immediate termination of operation and may be subject to forfeiture (47 CFR 1.80).
Pre-Installation Checklist
Before installing your 650 Series access points, ensure that you have the following:
A mount kit compatible with the AP and mount surface
n
Rev 01 | March 2022 | 5