Other Network Settings; Configure The Wl520 Device As A Dhcp Server - HP WL520 User Manual

other network settings

other network settings other network settings other network settings
You may want to set other configuration parameters for your WL520 unit, such as:

— Configure the WL520 device as a DHCP Server

— Maintain 802.11b client connections using Link Integrity
— Change your Wireless Interface settings
— Configure which physical interface will be used to manage the WL520 unit
— Control access to the WL520 device using MAC Address authentication, WEP encryption, or 802.1x security
settings
Refer to Configuring Advanced Features
configure the wl520 device as a dhcp server configure the wl520 device as a dhcp server configure the wl520 device as a dhcp server configure the wl520 device as a dhcp server
CAUTION:
!
Make sure there is only one DHCP server on the network and do not enable the DHCP server without checking with
your network administrator first, as it could bring down the whole network.
Use DHCP configuration to provide dynamic client IP Addresses from one or more IP Pool Tables. Enable the DHCP Server to
allow the WL520 to assign clients IP Addresses from IP Pool Tables. Deselect the Status check box to prevent client IP Address
assignment from the WL520.
NOTE:
You must have at least one entry in the DHCP Server client IP Address assignment table before you can enable the
DHCP Server Status feature.
Figure 2-12 Figure 2-12 Network Configuration Screens - DHCP Server Network Configuration Screens - DHCP Server
Figure 2-12 Figure 2-12 Network Configuration Screens - DHCP Server Network Configuration Screens - DHCP Server
1. In the Web Interface, click the
2. Select the
DHCP Server DHCP Server
DHCP Server DHCP Server
3. Click the button in the IP Pool Table.
Add Add
Add Add
for more complex network settings.
button and select the
Configure Configure Configure Configure
sub-tab.
Other Network Settings
tab.
Network Network Network Network
2-11