Table of Contents
Advertisement
Connection of liner to rebox
The vent plate will ultimately locate approximately 19”"
above the base of the replace once inserted.
1. Trim the liner accordingly so it will not be too long
once the rebox in raised.
2. Connect the liner to the vent plate using the gear
clamp provided.
3. Stretch the liner down and slide the rebox onto the
vent plate.
4. Secure the vent plate to the rebox using 2 screws
through the front tab.
NOTE: When installing into larger replaces, the RF24
may be connected to the liner while sitting out on the
hearth or inside the replace without removing the vent
plate.
The support legs may also be left in place if the
replace is large enough.
If the liner is connected to the rebox on the hearth, it
will be necessary to pull the slack liner up from the top
of the chimney after the rebox is installed.
Reinstallation of support legs (if removed)
With the rebox recessed behind the smoke curtain
of the existing replace, raise the rebox and place
the individual support legs under the rebox. Placing
a temporary shim under the rebox, such as a 2”" x 4”",
Raise right side of firebox and slip
RH support leg under. Fasten with
2 bolts as indicated.
Firebox Installation
may help while positioning the support legs. Tabs are
provided on the support legs to help position them.
Fasten the support legs at the points indicated by the
arrows using the bolts provided (2 per side).
Trim Liner and Connect
Vent Plate to Liner using
Gear Clamp provided
Vent Plate
Slide Firebox onto
Vent Plate
Secure Vent Plate
using 2 screws at
Front
Firebox with Legs and
Burner Removed
Raise left hand side of firebox and slip
LH support leg under. Fasten with
2 bolts as indicated.
QUALIFIED
INSTALLER
Approx. 19"
above base
of fireplace
19
Advertisement
Table of Contents
