Rear Cover - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

4.2.6 Rear Cover

1. From the rear side, remove two screws (CPS: M3×12), and remove the blank panel.
(See Figure 4-16)
2. Remove the two screws (CP: M3×6) securing the parallel interface and remove the one
screw (CBS: M3×6) securing the USB interface.
3. Remove one screw (CBS: M3×6) holding the AC inlet top.
4. Remove the three screws (CBS: M4×8) (six screws for Stylus Pro 9600) holding the
rear cover bottom.
5. Open the Roll Paper Cover.
6. Remove the three screws (CBS: M4×8) (six screws for Stylus Pro 9600) holding the
rear cover top, then remove the rear cover, while pulling it rearward.
To avoid getting hurt with sharp frame edges, be sure to wear
C A U T I O N
gloves when performing the following work:
Removing and installing the Rear Cover
Inserting your hand through the opening in the Access Cover
(see Check Point on the next page)
Disassembly & Assembly
(See Figure 4-17)
Removing the Panel Unit and Housing
Screws (CPS: M3×12) ×2
Screws (CPS: M3×6) ×2
Figure 4-16. Rear Cover Removal 1/2
Screws (CPS: M4×8) ×3
Screws (CPS: M4×8) ×3
Figure 4-17. Rear Cover Removal 2/2
Revision A
Blank Panel
Screw (CPS: M3×6)
Screw (CPS: M3×6)
166