Detect Paper Width; Detect Skew Error; Job Timeout Setting - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600
Roll Paper Width X
X
Figure 1-8. Roll Paper Margin (1)
Roll Paper Width X
X
Figure 1-9. Roll Paper Margin (2)
Product Description
X (*)
Printable Area
X
X
Cut Position or Border
Clipped Area
X (*)
Printable Area
X
X

1.4.3.8 Detect Paper Width

When the paper width detection function is OFF, the printer can print on the platen if
the image to be printed is bigger than the set paper (larger than borderless print area).
Therefore the user must bear responsibility in selecting this function OFF setting. At
Vertical
Line
paper initial feeding or print starting, the paper is fed by the distance between grid
roller and #1 nozzle unconditionally. The print starts from that position. (No back-feed
in the other sequences) Even when paper has too low reflection to be detected, the
paper is fed so as not to print on the platen.
The same specifications are applied to sheets and auto loading.
The above-mentioned paper width detection OFF sequence is just for the first page in
the case of roll paper.
The paper auto cutting function does not check whether paper is cut successfully or
not.

1.4.3.9 Detect Skew Error

With PAPER NOT STRAIGHT = OFF setting, the "PAPER NOT STRAIGHT" error
will not be displayed and printing will be continued.
With this setting, even if the printing image is out of paper because the paper is not
straight, the printer will not inform the user of such an error. Therefore, the user must
bear responsibility in selecting this function OFF setting.

1.4.3.10 Job Timeout Setting

When print data is interrupted longer than setting time although data receiving is
available, the print job is regarded as the end, and the printer runs paper feeding
operation.
Operating Panel
Revision A
42