Epson Stylus Pro 7600 Service Manual page 235

EPSON Stylus Pro 7600/9600
Dye code input
In this mode, input a dye code by operating on the panel.
The cursor is displayed at the position where a digit is currently input.
(See Figure 5-25)
Press [Cleaning] key to shift the cursor (pointing out the input item) to the
right.
The cursor moves to the left end when [Cleaning] key is pressed at the right
end.
After ink charge, the display returns to the adjustment top menu.
Press the [Pause] key to return to the previous level in the hierarchy.
In doing so, note that the input code is valid but it has not been registered yet.
The cursor skips the item displayed with "\".
At input for "Dye-1" or "Dye-2", press the [Enter] key to enter the input line
selection mode, which is the immediately upper level in the hierarchy.
Adjustment
Dye–1
? 266432F
Dye–2
? 44WM2Q3
Dye–3
? NU00G\\
[Enter]
Exc. EnterKey Fill
[Enter]
Please Set Ink
[Enter]
INK CHARGING
Figure 5-25. Menu Transition of Code Input
Self-diagnostic Function
∆
[Paper Feed ] Key : +
∇
[Paper Feed ] Key : –
Press [Pause] key for transition to the adjustment top menu.
Displayed when the cartridge has not been installed.
Revision A
235