Error Display; Errors; Error Indications On Lcd - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

3.2 Error Display

The printer displays the relevant error message on the LCD and the error status by
LEDs. At the same time, it stops not only printing operation but also receiving data
from the host PC. (Among the interface signals, the "-ERROR" signal is turned "low"
and the "BUSY" signal is turned "high" to inhibit data input.)

3.2.1 Errors

Errors, Warnings and service call errors (fatal errors) are described below.

3.2.1.1 Error Indications on LCD

Table 3-1. Error Indications on LCD
LCD Panel Message
SERVICE REQ. nnnnnnnn Fatal error*
COVER OPEN Cover open error
LOAD PAPER Paper set lever is released during operation
PAPER JAM Paper jam
INK OUT Ink out error
NO INK CARTRIDGE No ink cartridge
INVALID CARTRIDGE Wrong ink cartridge
SET INK CARTRIDGE Defective ink cartridge
PAPER OUT Paper out error
• Ink sequence currently executed
• Paper currently initialized
COMMAND ERROR
• Timer IC reset
/NVRAM clear
• Wrong setting with roll paper and sheet
(Roll paper)
LOAD XXX PAPER
• Wrong setting with roll paper and sheet
(Sheet)
RELOAD PAPER Problem with paper output (sheet)
MAINTENANCE TANK FULL Maintenance tank full
PAPER NOT CUT Paper cutting error
Troubleshooting
Printer Status Refer to
p.127
p.126
p.127
p.130
p.130
p.130
p.131
p.126
–
p.126
p.129
p.131
p.128
Error Display
Table 3-1. Error Indications on LCD (continued)
LCD Panel Message
LOWER PAPER SET LVR Paper set lever is released
REMOVE PAPER Paper is too thick for cleaning
RELOAD PAPER Paper check error
PAPER NOT STRAIGHT Paper not straight
INVALID CARTRIDGE Non-genuine cartridge
SET INK LEVER Ink lever released
NO MAINTENANCE TANK No maintenance tank
COMMAND ERROR Command error
OPTION I/F ERROR Type-B I/F error
Note : The status can't be replied during service call.
Revision A
Printer Status Refer to
p.127
p.129
p.128
p.130
p.130
p.131
p.131
p.128
123