Troubleshooting For Service Call Errors; Cr Motor Life (00000101) - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

3.2.4 Troubleshooting for Service Call Errors

If any service call error has occurred, Stylus Pro 7600/9600 inhibits interruption,
restores the actuators to their respective initial positions, writes the NVRAM values as
a rule, and makes all the LEDs on the panel flash.
Description:
Occurrence of any error from which the user can not recover the printer.
Life expiration of a long-life part which can cause secondary problems if the
part is further used.
The printer has been brought into malfunction by unexpected operation or by
receiving an unexpected command.
Solution:
Turn the power off once and turn it on again. If the error display is cleared, try to
continue using the printer.
If the error of the same code has occurred again, the service technician must
replace the relevant part with a new one. Then the error display will be cleared.
NOTE: See "3.2.1.3 Service Call (Fatal) Errors
Troubleshooting
(p.125)".
Error Display

3.2.4.1 CR motor life (00000101)

Problem:
The number of carriage round trips has reached the specified value.
Specified value:
Stylus Pro 9600: 2,500,000 passes (B0/Speed)
Stylus Pro 7600: 3,250,000 passes (A1/Speed)
NOTE: 1 Pass = 1 round trip
Remedy:
1. Replace the CR Motor and Driven Pulley.
2. Check the Head FFC for breakage, scratches on the surface or damage.
Check the ink supply tube for cracks, breakage or ink leakage.
3.
4. Check the CR motor life by
([SelecType] key → "PRINTER STATUS MENU"
→ "SERVICE LIFE")
When the life of the CR motor has been almost expired:
Replace the CR Motor ASSY (p.180).
•
When the CR motor has still an adequate life remaining.:
Replace the MAIN Board (C472 MAIN) (p.207).
•
After replacing the CR Motor, execute
C H E C K
life" (p83) in "Maintenance Mode 2".
P O I N T
Do not initialize the CR Motor cumulative counter value ("CR
TOTAL").
Revision A
"SelecType" (p.35).
" Initialize CR motor
134