Write D/A Value - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600
Pigment Code Input
After ink filling, the display returns to the adjustment top menu.Pigment Code
Input
In this mode, input a pigment code by operating on the panel.
The cursor is displayed at the position where a digit is currently input.
Press [Cleaning] key to shift the cursor (pointing out the input item) to the
right.
The cursor moves to the left end when [Cleaning] key is pressed at the right
end.
After ink charge, the display returns to the adjustment top menu.
Press the [Pause] key to return to the previous level in the hierarchy.
In doing so, note that the input code is valid but it has not been registered yet.
The cursor skips the item displayed with "\".
At input for "Pigment-1" "Pigment-2" or "Pigment-3", press the [Enter] key
to enter the input line selection mode, which is the immediately upper level in
the hierarchy.

5.2.3.4 Write D/A Value

Stylus Pro 7600/9600 does not incorporate this function. Do not try
C A U T I O N
to execute this operation on the service site.
Adjustment
Pigment–1
266432F
Pigment–2
44WM2Q3
Pigment–3
QVVWUVR
Pigment–4
S01S0\ \
[Enter]
Exc.EnterKey Fill
[Enter]
Please Set Ink
[Enter]
INK CHARGING
Figure 5-26. Menu Transition of Code Input
Self-diagnostic Function
∆
[Paper Feed ] Key: +
∇
[Paper Feed ] Key: –
∆
[Paper Feed ] Key: +
∇
[Paper Feed ] Key: –
∆
[Paper Feed ] Key: +
∇
[Paper Feed ] Key: –
∆
[Paper Feed ] Key: +
∇
[Paper Feed ] Key: –
Press [Pause] key for transition to the adjustment top menu.
Displayed when the cartridge has not been installed.
Revision A
236