Cutter Positioning Adjustment - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

5.3.7 Cutter Positioning Adjustment

This adjustment should definitely be mad if the following parts are removed.
Parts
Cutter Solenoid Assy 1. Paper Guide L up and down adjustment
2. Cutter Holder ASSY height adjustment
Paper Guide L 1. Paper Guide L up and down adjustment
This adjustment is intended to install the cutter at a proper position and height relative
to the step for the cutter on the Paper Guide L. The number of adjustment items
required depends on the parts replaced. Carry out work by referring to the table above.
Adjusting tools: Cutter positioning jig #F800
NOTE: For disassembly and assembly procedure, refer to
(p.175)".
For adjustments at replacing the Cover Sensor ASSY, make the
C H E C K
Paper Guide L up and down adjustment first and then make the
P O I N T
Cutter Holder ASSY height adjustment.
1. Remove the H Top Cover. (p.165)
NOTE: For Stylus Pro 9600, remove also the
Tube Cover (p.193).
2. Open the Front Cover, and remove the cutter.
3. Return the CR Unit to the cap position and set the cutter positioning tool at the right
end of the Paper Guide L. (See Figure 5-73)
4. Loosen the screws securing the Paper Guide L.
NOTE: 3 screws for Stylus Pro 7600 / 5 screws for Stylus Pro 9600
To loosen the screw at the left end of the Paper Guide L, pass the
C H E C K
screwdriver through the cut portion of the I/H Frame Top Plate.
P O I N T
(See Figure 5-72)
Adjustment
Adjustment Items
"Cutter Holder ASSY
H Top Cover (p.165) and the
Mechanism Adjustment
Cutter Holder ASSY height adjustment
Paper Guide L up and down adjustment
Figure 5-71. Cutter Positioning Adjustment
Figure 5-72. Removing the screw for Paper Guide L (at left end)
Revision A
Cut portion of I/H Frame
269