Delivery Roller; Disconnecting The Dadf; Removing The; Removing The Main Cover - Canon DADF-Q1 Service Manual

Chapter 3
[3]
8) Remove the E-ring [2] at the rear of the separation roller [1] to detach the
separation belt [3].
[1]
[3]

3.4.5 Delivery Roller

3.4.5.1 Disconnecting the DADF

1) Turn off the copier.
2) Disconnect the DADF's communication cable [1] from the copier.
3) Open the DADF fully.
4) Standing at the rear of the copier, lift the DADF to detach.
MEMO:
The hinge foot is equipped with a locking mechanism, requiring the DADF
to be fully opened for removal.
Lift.
3.4.5.2 Removing the Front Cover
1) Remove the front cover [1].
-Three screws [2] (remove)
-One screw [3] (loosen)
3-18
[2]
[1]
F-3-122
[2]
F-3-123
[1]
F-3-124
F-3-125
F-3-127
0011-8141
F-3-128

3.4.5.3 Removing the Main Cover

1) Open the upper cover, and insert a screwdriver from above the hook; then,
remove the two hooks [1].
2) Free the hook of the pickup assembly cover [2] from the right stay; then,
detach it while paying attention to the hooks on the front and rear side
plates.
0011-8139
F-3-126
[1]
[1]
F-3-129
0011-8140