Cross Section; Using The Machine; Original Set Indicator - Canon DADF-Q1 Service Manual

1.2.2 Cross Section

[23] [22]
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]

1.3 Using the Machine

1.3.1 Original Set Indicator

The Original Set Indicator [1] goes on when an original is placed on the original tray, and flashes when a jam occurs.
-Warnings and Action to Take
If the Original Set indicator starts to flash while an original is inside the DADF, suspect a jam; go through the following to remove the jam:
1) Remove all originals from the original tray.
2) Open the upper cover, and remove the jam, if found.
3) Open the DADF, and remove the original from the copyboard glass, if found.
4) Put the originals back into initial sequence, and place the stack in the DADF.
[1] [2] [3] [4] [5] [6] [7] [8]
[18] [17]
[21] [20] [19]
Reversing roller B member
Reversing roller B
Reversing flapper
Registration pressure roller
Registration roller
Pull-off roller
Pull-off pressure roller
Feeding roller
Pickup roller
Manual feed registration roller
Manual feed stopper plate
elivery roller A member
[9]
[16]
F-1-2
[13] Delivery roller B member
[14] Delivery roller
[15] Delivery guide flapper
[16] Feeding belt
[17] Stopper plate
[18] Separation belt
[19] Feed belt driver roller
[20] Guide flapper
[21] Pre-reversal flapper
[22] Reversing roller A
[23] Reversing roller A member
F-1-3
[10] [11] [12]
[15] [14] [13]
Chapter 1
0011-1993
0011-2222
1-3