Removing The Main Cover; Removing The Separation Motor Unit - Canon DADF-Q1 Service Manual

Chapter 3
F-3-22

3.3.2.2 Removing the Main Cover

1) Open the upper cover, and insert a screwdriver from above the hook; then,
remove the two hooks [1].
[1]
2) Free the hook of the pickup assembly cover [2] from the right stay; then,
detach it while paying attention to the hooks on the front and rear side
plates.
[2]
3) When you have removed the ADF controller cover, disconnect the con-
nector [3] of the ADF controller PCB; then, remove the screw [4], and re-
move the grounding wire [5]. Free the harness from the wire saddle [6],
and detach the other saddle [7].
3-4
[1]
F-3-23
Hooks
F-3-24
0011-8130
4) Remove the four screws [1], and detach the main cover [2].
The main cover is fitted with the original tray [3], and cables are connected
to it. Take extra care when removing it not to damage the cables.

3.3.2.3 Removing the Separation Motor Unit

1) Remove the screw [1], and detach the separation motor sensor support
plate [2].
2) Disconnect the two connectors [1].
[7]
Freed.
Push.
[5]
[4]
[6]
[3]
F-3-25
[1]
[1] [3]
[2]
[1]
F-3-26
[1]
[2]
F-3-27
[1]
0011-8131